Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15
  1. #11
    Join Date
    Dec 2016
    Location
    Berkshire
    Posts
    235
    Liked
    22
    Iíll have to measure it up tomorrow as itís pitch black outside now. Iím not sure if mine are right in the centre of the holes but Iíll grab a few photos when I measure it all up tomorrow Aero wing bolt holes

  2. #12
    Join Date
    Feb 2017
    Location
    Auckland, New Zealand
    Posts
    31
    Liked
    2
    Thank you sir.

  3. #13
    Join Date
    Dec 2016
    Location
    Berkshire
    Posts
    235
    Liked
    22
    Didnít get any measurements as it was tricky to actually measure against any points of reference.

    BUT, I did have a look at the bolt holes and they are in the centre of the pre-formed large holes in the boot lid. If you can mark a hole perfectly in the centre of that you should be fine.

    Also found out (as the drivers side holes on mine are off centre and so I measured the postsí position on the outside) that my spoiler has been put on wonky. Aero wing bolt holes

  4. #14
    Join Date
    Feb 2017
    Location
    Auckland, New Zealand
    Posts
    31
    Liked
    2
    Oh ok, cool. Thanks for that.

  5. #15
    Join Date
    Nov 2007
    Location
    Sunny Tweed Heads
    Posts
    2,098
    Liked
    28
    The Angry Saxon is spot on, just drill in the centre of those two holes on either side of the boot lid

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •