HKS adjustable actuator setup with ebc

[raytsang]

ok guy's
got a HKS adjustable actuator installed and was wondering do i need what i need to do as in set up wise..

do i just plum it in with any old lenght and let the boost controller take over or do i need to turn off the boost controller and set it up to the stock boost setup???

cause after plumbing it in with any old lenght and letting the controller take over im getting lots of noises coming from the area, not sure if it's the turbo spooling up or just the solenoid at boost.

any help would be great.

 

[Nicely]

The length of hose going to the actuator should be a short as possible. To set it, you need to turn the boost off on your EBC, set the actuator arm about half length, then check peak boost by flooring it from 3500rpm in 5th/6th. Check peak boost and adjust the actuator arm accordingly when the manifold has cooled. Try to aim for 0.7 bar.

You may need to adjust your EBC for the actuator's new setting.

 

[raytsang]

cheers nicely.
that exactly what i need. :thumbs:
think it's close to one bar when i floor it with no EBC.
So think solenoid was working its ass off.