What's new

New Owner, Gearbox/Clutch Making All Kinds of Noises. Videos Included PLEASE HELP!

Joined
9 September 2014
Messages
91
Reaction score
0
Points
0
Location
Sheffield, England
Country
In the past week my gearbox has developed 3 different sounds!

The first one is when I put the clutch down while in gear.

[video]http://vid1201.photobucket.com/albums/bb349/packham92/20140917_135701_zpspj8a6yh8.mp4[/video]

The Second one is a lot more quieter and happens when lifting the pedal up.

[video]http://vid1201.photobucket.com/albums/bb349/packham92/20140917_140608_zpse93yxtjk.mp4[/video]

The third one is when revs are around 1.5k to 3k rpm and I lift off the throttle.

[video]http://vid1201.photobucket.com/albums/bb349/packham92/20140915_184645_zpsot0vouno.mp4[/video]

I'm hoping all of these are just some bearings which can be replaced. I've changed the gear oil and its made no difference at all :confused:

Any help will be greatly appreciated! :thumbs:
 

S15_SAM

NisSam
Joined
21 February 2011
Messages
1,915
Reaction score
0
Points
0
Location
Chippenham, wiltshire
Country
Could be release bearing, but either way you need to remove the gearbox and inspect. More then likely an internal bearing! Contact garage D in the midlands they do a strengthened 6 speed box built buy quaife. And do a gearbox trade in deal.
 
Joined
9 September 2014
Messages
91
Reaction score
0
Points
0
Location
Sheffield, England
Country
Hopefully a mechanic will be looking at it tomorrow. So you think that would be the best option rather than replacing the barings?

Sent from my GT-I9505 using Tapatalk
 
Joined
9 September 2014
Messages
91
Reaction score
0
Points
0
Location
Sheffield, England
Country
Had a full new baring kit and one of the noises has stopped. It is still rattling but I think this is the quick shift.
But the guy who did my box said it was mint inside not a single issue but now I have no reverse when it is slightly warm! :(

Sent from my GT-I9505 using Tapatalk
 
Joined
17 March 2009
Messages
204
Reaction score
0
Points
0
Location
New Zealand
I used to have problem similar to yours on the third video. but that noise is gone when I replaced the clutch and the slave cylinder.
 
Joined
9 September 2014
Messages
91
Reaction score
0
Points
0
Location
Sheffield, England
Country
That noise is sorted and the second one is normal so I'm told so I'm not worried about that now. It's just reverse that is puzzling me :/

Sent from my GT-I9505 using Tapatalk
 
Joined
7 November 2013
Messages
30
Reaction score
0
Points
0
Location
London
Country
The first noise seems to be the release bearing or pilot bush, mine sounded the same but i replaced both at the same time and it cured it so not sure what one and the second is the gearbox input shaft bearing. Not sure on the third, either way its box out job.
 
Top