Im in the middle of fitting the Map And AIT sensors where I want them and im now on the task of fitting the wiring looms to go down the the ECU.
Now the hole in the firewall behind the intake manifold is full of gauge wiring etc so that one is out of the question, I have noticed the main harness boot in the firewall by the abs unit that the main harness runs through now I was thinking of integrating them into this but I think its going to be a PITA :nod:
could some of you guys running Djets just have a quick look to see where they are running?
Cheers :thumbs:
Now the hole in the firewall behind the intake manifold is full of gauge wiring etc so that one is out of the question, I have noticed the main harness boot in the firewall by the abs unit that the main harness runs through now I was thinking of integrating them into this but I think its going to be a PITA :nod:
could some of you guys running Djets just have a quick look to see where they are running?
Cheers :thumbs: