What's new

Fitting Apexi ECV, advice.

subzero

Joined
2 June 2007
Messages
1,286
Reaction score
2
Points
38
Location
Limerick Ireland
just wondering has any one fitted an apexi exhaust control valve , and where they ran the cable into the cabin .

been looking and dont want to drill through the body of the car, in through the gear lever area ?
 
Joined
28 October 2012
Messages
290
Reaction score
0
Points
0
Location
Northamptonshire
Country
Dude I haven't done one myself but they'll be spare rubber bungs on the bulkhead somewhere. People utilise them for allsorts. Gauges/alarm/ECVS etc
 

S15_SAM

NisSam
Joined
21 February 2011
Messages
1,915
Reaction score
0
Points
0
Location
Chippenham, wiltshire
Country
I'm sure there's one or two in the boot and then some under the rear seats/floor. Just make sure you seal the whole up with silicon etc.
 
Joined
8 November 2009
Messages
4,636
Reaction score
44
Points
48
Location
herts,uk
Country
Instagram
@Peglio13
I had one on my car had the actual lever to pull mounted in my glovebox and the cable came up under the passenger seat and under the carpet to under the dash
 

subzero

Joined
2 June 2007
Messages
1,286
Reaction score
2
Points
38
Location
Limerick Ireland
thanks lads .... i was only under the car on axle stands, ill give it a good look when on the lift so . hopefully the cable will reach through the bulk , would be handy .

have one on my ae86 and it went easily up through the the handbrake area but will be akward on the s15.
 
Top