Plumbing in a gizzmo

[teejay43]

Anyone know the safe/ easist place to plumb in the pressure pipe that comes out of the control unit on a Gizzmo ebc. Noob question maybe but i know nowt about ebc.
thanks in advance :thumbs:

 

[JaseYpk]

for the display/controller - same place you tee most things into - the vacuum hose coming from the top of the BOV, leading to to the inlet. you tee off here for boost gauges too. i've got several 'tee's here and it all works fine

theres a guide on here for 'Fitting a Defi Boost Gauge', it shows the tee point there.

for the solenoid - one off the actuator, and one somewhere along the intercooler system. i've got mine coming off the first section after the intercooler. but as far as i'm aware it doesnt make a difference. i just chose a cooler section in my attempts to keep temperatures down and make it last longer lol

 

[teejay43]

thanks for the info . Jase cheers mate:notworthy:

 

[JaseYpk]

no worries just make sure you put the 'inlet and outlet' nipples in the correct holes on the solenoid (check the manual)

 

[teejay43]

Yeah ok thanks again cheers mate:thumbs: