I am currently in the process of swapping a RB25 into my Spec S.
Since im going to run aprox 400bhp I was wondering if the Spec S half axles are equal to the Spec R and can handle the power?
I've been trying to find some information about if these are the same or not.
Same with the driveshaft. Im thinking the Spec S driveshaft is thinner then the Spec R.
I've got the front bit which will fit into the RB25 box but I was planning on using the rear end of the Spec S shaft. If this one is thinner then then Spec R Im just going to find a S14 driveshaft and use the end of that instead to be sure.
Do any of you know if there even are differences in these parts?
Since im going to run aprox 400bhp I was wondering if the Spec S half axles are equal to the Spec R and can handle the power?
I've been trying to find some information about if these are the same or not.
Same with the driveshaft. Im thinking the Spec S driveshaft is thinner then the Spec R.
I've got the front bit which will fit into the RB25 box but I was planning on using the rear end of the Spec S shaft. If this one is thinner then then Spec R Im just going to find a S14 driveshaft and use the end of that instead to be sure.
Do any of you know if there even are differences in these parts?